Kunshan Shengye Packing Material Co., Ltd
Service line
Export manager: 18962691776
Sales manager:18068053703
Application contact
Mr. Li: 18616678980
Customer service QQ online:
1034841868(James) 2477928383(Sonia) 605048188(Mr.li)
Web: www.ksypack.cn
Add: Jiangsu province Suzhou city Chinese town Kunshan City International Business City
Sales: North Kunshan Road, No. 1288 is Tyrone International Trade City Shop No. 1023-1025
Sealing machine common fault analysis and solutions introduced in the daily operation of the machine may encounter some common problems, so understand the causes of failure and solutions to quickly troubleshooting.
Fault one, sealing machine clip nail action is too slow or clip nail stroke is insufficient
Failure analysis solution: the bolt is loose, the front buckle or plate machine film wear. At this point you can tighten the bolt, pay attention to the correct position of the front shaft. You can also replace the front buckle or plate machine film, to complete the above action, test its function, if the trip is too short to fine up the front axle, if the action is slow down the fine before the shaft;
Failure two, the piston rod at the leak
Failure Analysis Solution: The bottom of the main part is damaged. Replace the ring at this time.
Failure three, exhaust leak
Failure Analysis Solution: The switch valve ring or switch seat ring is damaged or the piston ring is damaged. Replacement ring.
Fault four, the trigger at the leak
Failure analysis solution: switch valve ring or switch seat ring damage. Replacement ring.
Fault 5, the transmission ring can not be loose positioning
Failure analysis solution: plastic steel and transmission spring inelastic. Remove the combination of the plates and re-install or replace the spring and the plastic spring.
Failure six, the tape can not be cut off, this situation may be due to the blade is not sharp enough to cause congestion.
Failure Analysis Solution: Just replace the new blade.
Fault seven, the tape can not be completely bonded box, there may be tape quality, but there is a situation that is loosened spring loosening tape can not work properly.
Failure Analysis Solution: Just replace the spring to solve.
Failure eight, the work of the box was stuck, the reason may be too tight nut or box height and sealing machine is not suitable for the size caused. Need to adjust to the appropriate height size. seal tape
Failure analysis solution: need to adjust to the appropriate height size.
Failure nine, sealing process, the tape easily broken.
Failure Analysis Solution: This may be caused by a long blade
Kunshan Shengye Packing Material Co., Ltd
Contact person: Mr. Li
Telephone: 18616678980
Export manager: 18962691776
Sales manager:18068053703
Web: www.ksypack.cn
Contact Us